FREE GROUND SHIPPING on orders over $199.00!

*Exclusions Apply*

LSTHD8RJ Strap Tie Holdown

Simpson Strong-Tie

(No reviews yet) Write a Review
Retail Price: $29.12
Sale Price: $21.57
Usually ships the same business day
G90 Galvanized
Adding to cart… The item has been added

Product Overview

LSTHD8RJ Strap Tie Holdown

The STHD is an embedded strap-tie holdown offering high loads and a staggered nail pattern to help minimize splitting. The STHD incorporates many features that aid correct installation and improve performance. When installed on the forms with the StrapMate strap holder, the unique design of the STHD delivers enhanced stability before and during the pour to help prevent both parallel and perpendicular movement (relative to the form). This results in accurate positioning of the strap and reduced possibility of spalling.

Key Features

The nailing pattern allows for nailing to the edges of double 2x's

Strap nail slots are countersunk to provide a lower nail head profile

The slots below the embedment line enable increased front-to-back concrete bond and help to reduce spalling

Rim joist models accommodate up to a 17" clear span without any loss of strap nailing


LSTHD8, LSTHD8RJ — 14 gauge; all others — 12 gauge


Galvanized (G90)


See General Notes for Holdowns and Tension Ties.

Use all specified fasteners; see General Notes.

Use tables for both standard concrete and post-tension slab installations.

Install before concrete pour with a StrapMate, or other holding device.

Nail strap from the bottom up. Install strap plumb.

Strap may be bent one full cycle (bent horizontal 90° then bent vertical) to aid wall placement, but may cause spalling behind the strap. If the spall is 1" or less, measured from the embedment line to the bottom of the spall, full loads apply. 1" to 4" spalls for LSTHD8 achieve 0.9 times table loads. STHD10 and STHD14 achieve full load for spalls less than 4". Any portion of the strap left exposed should be protected against corrosion.

Other than where noted in the two-pour detail, do not install where: (a) A horizontal cold joint exists within the embedment depth between the slab and foundation wall or footing beneath, unless provisions are made to transfer the load, or the slab is designed to resist the load imposed by the anchor; or (b) Slabs are poured over concrete block foundation walls.

Additional studs attached to the shearwall studs or post may be required by the Designer for wall sheathing nailing.

Wood shrinkage after strap installation across horizontal members may cause strap to buckle outward.

For installations in severe corrosion environments, refer to General Corrosion Risks for additional considerations.

See installation illustrations in the image gallery for rebar information.

For Two-Pour Installation for Downturn Footings -

For STHD10 installed through a 4"-thick slab, use the equivalent 8" stemwall loads of the LSTHD8 For STHD14 installed through a 4"-thick slab, use the equivalent 8" stemwall loads of the STHD10 For STHD14 installed through a 6"-thick slab, use the equivalent 8" stemwall loads of the LSTHD8


(No reviews yet) Write a Review