Product Overview
HTHMQR-2-SDS Heavy Multiple Truss Hanger
The HTHMQ is a versatile, high-capacity truss hanger designed for various lumber types and multiple-ply trusses. The truss hanger accommodates a greater range of structural designs while accommodating right- or left-hand hips (at 30°–60° skews), which can be used for terminal hips with or without the center common jack. The HTHMQ can accommodate various widths of lumber. Specify Skew (30°- 60°) in comment box when ordering.
Key Features:
Available in various stirrup widths to accommodate various lumber types and multiple-ply trusses
Installed with Strong-Drive SDS Heavy-Duty Connector screws that eliminate the inconvenience of bolted installation
Enables 2–3 member connection for a broader range of structural designs
Material:
Back plate — 3 gauge; stirrup — 7 gauge
Finish:
Simpson Strong-Tie Gray Paint
Installation:
Use all specified fasteners; see General Notes.
Strong-Drive SDS Heavy-Duty Connector screws supplied with connector.
All multiple members must be fastened together to act as a single unit.
Shall be attached to a minimum double girder truss to allow for required minimum screw penetration. See footnote 5.
Girders must be adequately laterally braced to prevent excessive displacement due to secondary torsional stresses (Ref ANSI/TPI 1-2014 Section 7.5.3.5).
See Image Gallery for different installation options.
The HTHMQ is a versatile, high-capacity truss hanger designed for various lumber types and multiple-ply trusses. The truss hanger accommodates a greater range of structural designs while accommodating right- or left-hand hips (at 30°–60° skews), which can be used for terminal hips with or without the center common jack. The HTHMQ can accommodate various widths of lumber. Specify Skew (30°- 60°) in comment box when ordering.
Key Features:
Available in various stirrup widths to accommodate various lumber types and multiple-ply trusses
Installed with Strong-Drive SDS Heavy-Duty Connector screws that eliminate the inconvenience of bolted installation
Enables 2–3 member connection for a broader range of structural designs
Material:
Back plate — 3 gauge; stirrup — 7 gauge
Finish:
Simpson Strong-Tie Gray Paint
Installation:
Use all specified fasteners; see General Notes.
Strong-Drive SDS Heavy-Duty Connector screws supplied with connector.
All multiple members must be fastened together to act as a single unit.
Shall be attached to a minimum double girder truss to allow for required minimum screw penetration. See footnote 5.
Girders must be adequately laterally braced to prevent excessive displacement due to secondary torsional stresses (Ref ANSI/TPI 1-2014 Section 7.5.3.5).
See Image Gallery for different installation options.
