Product Overview
CCTQ666SDS Column Cap “T” Configuration, Quick-Install
The CCTQ is designed to provide strong column-to-beam connections when there are two beams in a “T” formation on top of a column. When properly installed, this column cap helps to distribute the load from bisecting beams and provides support for the connection. The CCTQ uses Strong-Drive® SDS Heavy-Duty Connector screws to provide faster installation and a lower profile than standard through bolts and is special-ordered per specific details from the designer to accommodate the many combinations of beam and post sizes.
Key Features
- Screws are configured to provide high uplift design values
- Certified welds for confidence in strength and loading
- Diamond holes to provide temporary fastening
Material
- CCTQ3, CCTQ4, CCTQ4.62, CCCTQ6 — 7 gauge; all others — 3 gauge
Finish
- Simpson Strong-Tie gray paint. Also available in HDG; see Corrosion Information.
Installation
- Install 1/4" x 2 1/2" Strong-Drive SDS Heavy-Duty Connector screws, which are provided, in all round holes. (Lag screws will not achieve the same load.)
- No additional welding is allowed.
Options
- Available in widths up to 8" wide.
- Straps may be rotated where W1 ≥ W2.
- Many combinations of beam and post sizes can be manufactured (refer to worksheet Options for Multiple-Beam Column Caps, T-C-CCQLTC-WS).
- Column caps may be ordered without the column straps for field welding to a steel column, full loads apply for the beam and the post cap. Specify “No Straps” when ordering. Weld by designer. These models have no coating.
Ordering Information
- The L dimension varies depending on the width of the side stirrup (W3 or W4). Contact Simpson Strong-Tie for exact dimensions.
- Main-beam stirrup height (H1) is 7". Side-beam stirrups (H2 or H3) can vary in height, with a minimum height of 7". Specify the side stirrup height from the top of the cap.
- Example: Order CCTQ for 4x main beam, 6x post, with side beam flush on bottom, as a CCTQ46, and specify side beam sizes.
