Product Overview
PHC12 Panel Hoist Clip
Product Details
The PHC panel hoist clip allows easier installation and lifting of wall panels on the job and at assembly sites. The PHC clip features a small profile design to fit inside holes as small as 1.5". Contractors can either drill holes in the track onsite or have the track manufactured with holes for easier installation of the clip through the top track. The rolled edges and rolled hoist-edge-hole provide greater strength and give the capacity needed for heavy panel projects. Maximum and minimum screw patterns give you options for heavier or lighter load needs. The PHC hoist clip has been assembly tested for tension and panel pickup, providing an increased level of safety for panelizers, installers and engineers.
Key Features
Small profile to allow for easy installation through the top track
Greater top track strength with reduced opening size required for hoist clip to fit through top track
Rolled stiffener for increased strength across the entire length of clip Rolled hoist-edge-hole for increased strength and smooth mounting edge
Screw pattern options allow for varying load needs; fill round holes for minimum loads, or fill round holes and triangular holes for maximum loads
Chamfered top corners and minimized distance of material above hoist hole allow for the lifting device to slide freely without getting stuck
Assembly tested for tension and panel pick up at different angles for attachment to stud web
Optional panel hoist clip cover (PHC-C) available to cover track hole and create a tight connector fit for the concrete pour when embedding the installed hoist in concrete or other hole cover needs
Material: PHC12 — 97 mil (12 ga.), 50 ksi
Finish: Galvanized (G90)
Product Details
The PHC panel hoist clip allows easier installation and lifting of wall panels on the job and at assembly sites. The PHC clip features a small profile design to fit inside holes as small as 1.5". Contractors can either drill holes in the track onsite or have the track manufactured with holes for easier installation of the clip through the top track. The rolled edges and rolled hoist-edge-hole provide greater strength and give the capacity needed for heavy panel projects. Maximum and minimum screw patterns give you options for heavier or lighter load needs. The PHC hoist clip has been assembly tested for tension and panel pickup, providing an increased level of safety for panelizers, installers and engineers.
Key Features
Small profile to allow for easy installation through the top track
Greater top track strength with reduced opening size required for hoist clip to fit through top track
Rolled stiffener for increased strength across the entire length of clip Rolled hoist-edge-hole for increased strength and smooth mounting edge
Screw pattern options allow for varying load needs; fill round holes for minimum loads, or fill round holes and triangular holes for maximum loads
Chamfered top corners and minimized distance of material above hoist hole allow for the lifting device to slide freely without getting stuck
Assembly tested for tension and panel pick up at different angles for attachment to stud web
Optional panel hoist clip cover (PHC-C) available to cover track hole and create a tight connector fit for the concrete pour when embedding the installed hoist in concrete or other hole cover needs
Material: PHC12 — 97 mil (12 ga.), 50 ksi
Finish: Galvanized (G90)
