Product Overview
THJM2-4-SDS3 Multiple Truss Hip/Jack Hanger
The THJM is a non-welded hanger designed to carry radial-end jack framing and provide optimal efficiency for those multi-plane, angled bay roofs over breakfast, study and library alcoves. The unique patent-pending design of the THJM accommodates 2x4 girder bottom chords and uses our Strong-Drive SDS Heavy-Duty Connector screws for easy installation with minimal fasteners.
Key Features:
The THJM hangers are designed for installation with 1/4" x 3" Strong-Drive SDS Heavy-Duty Connector screws that are included with the parts.
The THJM2-4-SDS3 is designed for four incoming jack trusses with the outer jacks being 22 1/2° from the face of the girder and the inner jacks being 45° from each other and the outer jacks.
The THJM2-5-SDS3 is designed for five jacks coming into the hanger at 30° from the girder and each other.
Tabs on the seats of the THJM assist in the placement of the jacks and also include obround holes for optional slant nails (0.148" x 1 1/2") when increased uplift is required.
Material:
12 gauge
Finish:
Galvanized (G90)
Installation:
Use all specified fasteners; see General Notes
Each carried jack truss requires one 1/4" x 3" Strong-Drive SDS Heavy-Duty Connector screw installed into the bottom chord through the bottom of the hanger seat
For installation on girders with 2x6 or 2x8 bottom chords, install one additional 1/4" x 3" Strong-Drive SDS Heavy-Duty Connector screw in the triangular hole on each vertical strap
Install two 0.148" x 1 1/2" slant nails in the obround holes on each of the seat tabs to achieve the additional uplift load noted in the table footnotes
The THJM is a non-welded hanger designed to carry radial-end jack framing and provide optimal efficiency for those multi-plane, angled bay roofs over breakfast, study and library alcoves. The unique patent-pending design of the THJM accommodates 2x4 girder bottom chords and uses our Strong-Drive SDS Heavy-Duty Connector screws for easy installation with minimal fasteners.
Key Features:
The THJM hangers are designed for installation with 1/4" x 3" Strong-Drive SDS Heavy-Duty Connector screws that are included with the parts.
The THJM2-4-SDS3 is designed for four incoming jack trusses with the outer jacks being 22 1/2° from the face of the girder and the inner jacks being 45° from each other and the outer jacks.
The THJM2-5-SDS3 is designed for five jacks coming into the hanger at 30° from the girder and each other.
Tabs on the seats of the THJM assist in the placement of the jacks and also include obround holes for optional slant nails (0.148" x 1 1/2") when increased uplift is required.
Material:
12 gauge
Finish:
Galvanized (G90)
Installation:
Use all specified fasteners; see General Notes
Each carried jack truss requires one 1/4" x 3" Strong-Drive SDS Heavy-Duty Connector screw installed into the bottom chord through the bottom of the hanger seat
For installation on girders with 2x6 or 2x8 bottom chords, install one additional 1/4" x 3" Strong-Drive SDS Heavy-Duty Connector screw in the triangular hole on each vertical strap
Install two 0.148" x 1 1/2" slant nails in the obround holes on each of the seat tabs to achieve the additional uplift load noted in the table footnotes
